KATS (Kinematic Analysis Tools for Slopes) is a tool developed by Itasca that assesses instabilities caused by day-lighting wedges and planar failures formed when different structural sets interact with the orientation of a given slope. KATS main application is for bench-berm scale analysis, which is understood as a first step in the mining slope design process for moderate and competent rock masses. It is also possible to perform a kinematic analysis in inter-ramp scale.
Unlike other tools currently available on the geotechnical analysis market, through a single automated process KATSperforms a probabilistic or deterministic assessment of the behavior of a large number of slope configurations defined by many structural domains and many orientations and geometries of the slope. The results from the analysis can be provided using a variety of parameters, such as loss of crest, spill lengths, bench face angle distribution, etc. All these results allow a geometric definition of the interramp angles (IRA) that achieve the acceptability criteria defined by the operation from the point of view of stability and safety of personnel and equipment.
Advantages of KATS
Very quick analyses (a few minutes of computer time for a full open pit)
Simple and easy to learn
Most inputs are readily available at mine sites
Can be calibrated given the performance of the slopes
Estimates the spill length of the failure mode (not available in other commercial software)
Can apply a probabilistic approach to produce cumulative frequency analysis (CFA) charts (not available in other commercial software), which is a typical methodology for bench scale design
Itasca has announced the release of FLAC2D v9 Itasca has announced the release of FLAC2D v9, revolutionizing the way we analyze and predict... Leer mas
6th Itasca Symposium on Applied Numerical Modeling The next Itasca Symposium will take place June 3 - 6, 2024, in Toronto, Canada.... Leer mas
Itasca International Inc. announces the Selection of its New CEO Itasca International Inc. announces the Selection of its New CEO ... Leer mas
Próximos Eventos
23Set.
Getting Started with FLAC2D/FLAC3D
This training is an introduction to continuous modeling with FLAC2D and FLAC3D. At the end of the course, participants will master the ...
Leer mas
14Oct.
Getting Started with 3DEC
Live Online Introductory Training Course.
October 14-15, 2025...
Leer mas