Pulser Amplifier System (PAS) Hardware

The PAS is an expandable multi-channel (up to 36 channels) system that consists of the Pulser Amplifier Desktop units (PADs) and Pulser Interface Unit (PIU).

The PAS provides pre-amplification and switching between pulsing and receiving mode for all transducers in a multi-sensor array during an ultrasonic survey.

Each PAD has selectable gains between 30 and 70 dB, and a broad frequency response with a plug-in filter circuit to tailor the unit to the desired frequency range. The unit is software controlled over the PC USB interface.

  • Itasca has announced the release of FLAC2D v9 Itasca has announced the release of FLAC2D v9, revolutionizing the way we analyze and predict...
  • 6th Itasca Symposium on Applied Numerical Modeling The next Itasca Symposium will take place June 3 - 6, 2024, in Toronto, Canada....

23 9月
Getting Started with FLAC2D/FLAC3D
This training is an introduction to continuous modeling with FLAC2D and FLAC3D. At the end of the course, participants will master the ...
14 10月
Getting Started with 3DEC
Live Online Introductory Training Course. November 14-18, 2022....
3 12月
NEW TRAINING: Meshing in ITASCA Software
...